Application Instructions

  • Make sure that the chosen surface is flat and smooth, not irregular or textured;
  • Clean the area that you want to cover with an anti-grease cleaner (ensure the surface is dry before applying the sticker);
  • For a better and more durable finish, use a hair dryer to apply heat on the stickers already applied. With a soft cloth, apply some pressure. Make sure that you do this at the edges of the tiles;
  • Do not clean the stickers with abrasive products;
  • Do not apply the stickers on: walls with latex or silicone based paints; freshly painted walls (let them dry for around 3 weeks).

REMOVING

To remove use a hair dryer and apply heat on the stickers already applied. The heat will activate the glue, allowing it to be remove easier.

  • Positioning

    Position and align the piece on the wall with paper tape. Ensure the item is perfectly positioned on the application area.
  • Preparation

    Apply paper tape exactly across the centre of the piece. This will be the final position of the sticker. Rub with the spatula over the whole area with vinyl for it to gain adherence to the transfer tape.
  • Preparation

    Grab the left side and carefully pull the transfer tape (transparent layer). The vinyl should be glued to the transfer tape. If that is not the case, run the spatula over it again. Then, cut the backing paper (opaque layer).
  • Application

    Starting from the centre of the sticker (over the paper tape), rub with the provided spatula or a cloth as shown on the image and, at the same time, keep the transfer tape stretched.
  • Application

    Remove all the paper tape and repeat the previous step, this time on the right side. After you finish, apply pressure firmly using a cloth to ensure it's well glued.
  • Finishing

    Carefully, start removing the transfer tape, pulling it close to the wall, making sure the sticker stays on the wall. Apply heat with a hairdryer, then carefully apply pressure with a cloth for a perfect and more durable finish.
  • Cleaning

    Clean the chosen surface, with anti-grease cleanser if possible. Make sure that the chosen surface is free of dust, dirt, and humidity. Let it dry.
  • Preparation

    Remove around 15 cm of backing paper from the first piece. DO NOT remove the whole paper, this will help position the sticker.
  • Positioning

    Position and align the piece without backing paper on the wall. Make sure that the piece is perfectly positioned on the application area.
  • Application

    Rub with the provided spatula or a cloth as shown on the image. Pull the backing paper until the end.
  • Finishing

    Apply heat with a hairdryer to activate the glue. At the same time, use a cloth to apply pressure firmly all over the piece.
  • Cleaning

    Clean the chosen surface, with anti-grease cleanser if possible. Make sure that the chosen surface is free of dust, dirt, and humidity. Let it dry.
  • Positioning

    Align the piece with the upper edge of the area you want to cover. Pay attention to the edges around the piece.
  • Application

    Apply pressure firmly with a cloth. Press downwards carefully in order for the sticker to adhere properly.
  • Finishing

    Apply heat on the edges with a hairdryer to activate the glue for a perfect and more durable finish.

Our Suggestions